Now why would I be running #4 bare copper to the new water main?

And I am

@Merlin
Because it's smart.
The neutral wire coming into our house broke. the ground wire was non-existent.
A lot electronics that could not handle 240VAC fried because our house was suddenly all 240VAC.
Stuff fried and melted.
Run that ground.

@teengee @Merlin
This was not good. Electricity is sneaky. Have recently upgraded 2 panels on 2 houses - by my Union Master Electrician friend. Including 2 new ground rods each, and grounding to both sides of the water meter on copper pipes. Also whole a house GCFI and Arc-Fault breakers where required.
I feel much better.

@FireMonkey @teengee yikes. none of this as scary...

Have some flickering lights. Ruling out causes:
1) Local transformer surges - checked w/ neighbors, no flickering there - R/O'd

2) Reference ground was still on the old water main - no easy way of knowing if that was cut (very likely) or still runs for at least 20 ft underground. --> run new reference ground. (been in basement so not sure if flicker is gone, but don't notice it) 🤞

3) next would be, did prev owner overload a new run?

Follow

@Merlin @teengee
Flicker - yes check grounds...everywhere. Buena suerte!

Sign in to participate in the conversation

CounterSocial is the first Social Network Platform to take a zero-tolerance stance to hostile nations, bot accounts and trolls who are weaponizing OUR social media platforms and freedoms to engage in influence operations against us. And we're here to counter it.