Thought my garbage disposal motor had gone out because it stopped working.
Was annoyed at the loss of the convenience coupled with the fact I would have to deal with the manager and a person in my apartment to fix it…
I don’t know why, but I unplugged it and plugged it back in again, son of a bitch started working! 😂 whatevs
@Armchaircouch There's probably a reset button down bottom. 👍
I… why didn’t somebody tell me this! Thank you! @th3j35t3r
@Armchaircouch Have you tried switching it off and back on ag...
(If you get another 15 of these you can pretend this is a Microsoft Community Help Forum instead 🤣 )
@th3j35t3r
She might need to go into the Registry under the sink and change the HKEY/Local Policy/ garbage DWORD to 1.
@th3j35t3r Make sure you back up the garbage first though, @Armchaircouch 🤣
@th3j35t3r Actually, it's probably already backed up at least a couple of inches by now 🥁
If all else fails she could reverse the polarity on the encabulation gromet and slide a carrot up past the sprocket assembly while tapping vigorously on the overhead inverted plermdigit.
ASsk @kel he knows more about this stuff than me.
I tried reversing the polar grommet, and I got an error message, in Russian!
Explain that! @th3j35t3r @BillyBones @kel
@Armchaircouch @th3j35t3r @BillyBones @kel
Here's a diagram that should help...
@jdtasker @Armchaircouch @BillyBones @kel
^^^ Toldja. See. It's right there.
@th3j35t3r @jdtasker @Armchaircouch @BillyBones There's duct tape problems and there's WD-40 problems.
This sounds like a WD-40 problem.
no, forget the sphincter problem, there is no sphincter problem, no WD-40 required
You guys everything’s OK, I found this ‘the red button’. @kel @th3j35t3r @jdtasker 😂@BillyBones
@Armchaircouch @th3j35t3r @jdtasker @BillyBones It does exist!!