@jurban A few seconds with a heat gun will help with all that stringing. Before I got my heat gun I used to use a disposable lighter.
@MakerWerks
Thanks for the tip!
I'd still like to figure out how to minimize the stringing with this filament. I ran 14 test with a black PVA and reduced it down to nothing.
@MakerWerks
Could be. There are voids in the outer wall, so it's probable.
Yet, I placed the filament into a Sunlu dryer with a desiccant bag for 2 days.
I may just run through this spool and just see what the new batch delivers. I've got 100 hrs of printing ahead.
@MakerWerks
Interesting. Looks like an additional layer of control. That would be useful if I was planning to go into production!
My setup is a BOSSDelta300. Large capacity build space.
I bought it specifically to do this project.
@jurban Well, a delta is already a lot faster than standard bed slingers,
@jurban I'm playing around a lot with Klipper these days on my newest printer, the Ender-5 S1. The speed increase is notable.